The SCOM 7330) followed with a 4 second TX hangtime without CTCSS (PL).īy using reverse burst in the repeater, along with the mike hangup leadīeing grounded by the mike jumper in the GM300 node radio, I do not hear any It is set for 1ms hangtime with Motorola reverse burst ( this is setup in Transmit CTCSS is generated in the 7330 and There is no duplexer since I am only going 15 feet. Receiver and the exciter are being used during testing, RF to the power amp The repeater is a VHF GE Master II that is sitting on my test bench, the Talking to the GM300 everything appears to work correctly. Radio up for "And Squelch" as Motorola puts it. There is a shorting jumper from pin 3 to 4 on the mike plug. I am using the 16 pinĬonnector on the rear of the radio. Sorry if this is a bit long but I do not have a clue why this is happening.įirst my setup. 4 Attaching the Universal Connector Cover (Dust Cover) 1 What Your Dealer/System AdministratorĬan Tell You. Product Safety and RF Exposure Compliance.
This User Guide contains all the information you need to use the MOTOTRBO XPR Series Digital Portable Radios.ĭeclaration of Conformity. Consult the dealer or an experienced radio/TV technician for help.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and receiver.Reorient or relocate the receiving antenna.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Finding and Connecting to a Bluetooth Device.
Assignable Settings or Utility Functions.Product Safety and RF Exposure Compliance.